6711
Show"N"Tell ( Your Machines) / Re: Chiron FZ12 on its way sometime soon(ish)
« on: December 04, 2012, 03:02:42 PM »
Got the panel painted with primer and got the majority of the wiring done in it. Still have a network cable, a serial cable, a CanBus cable and two E-Stop lines to run. The CSMIO module in the pic is an extra I/O module for the buttons and I will fit a MPG module alongside it for the MPG, Pots etc, they will then connect to the main module which will be in the main control cabinet, via the CanBus cable.
I hope to get the serial cable in sometime this week, that will allow me to connect the PLC to the computer and I will then be able to test out the toolchanger and hope I have the ladder right
Hood
I hope to get the serial cable in sometime this week, that will allow me to connect the PLC to the computer and I will then be able to test out the toolchanger and hope I have the ladder right
Hood