2821
General Mach Discussion / Re: Use of tools in a turret?
« on: March 07, 2012, 06:43:35 AM »
BTW, Luppie was a friend in Corpus Christi , Texas.....
RICH
RICH
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
This is a pre-purchase decision. With all due respect, do not waste my time with, stop what you are doing and do it my way, class of comments.
All I want of MACH 3 is to visualize the cutting if possible, output Gcode that I can load into my controller and translate VB scripts that I may write.There are manny wizards which provide gcode for common maching task and those that get more complex are somewhat handled by LazyCam or LazyTurn.