Messages

841

General Mach Discussion / Re: NEED HELP Mach3 and 2HSS86H problem on AXBB-E

« on: September 21, 2020, 07:07:57 AM »

have you tryed to Change Motor direction by swapping A and B wire's ?

842

General Mach Discussion / Re: NEED HELP Mach3 and 2HSS86H problem on AXBB-E

« on: September 21, 2020, 06:44:53 AM »

btw your link is not working.

843

General Mach Discussion / Re: Demo version

« on: September 21, 2020, 01:59:27 AM »

i am affraid, this usb Controller will not supply M10/M11 funtions.

844

General Mach Discussion / Re: XHC ethernet controller & PROMA 150 THC

« on: September 19, 2020, 02:10:10 AM »

Short answer NO.

845

General Mach Discussion / Re: NEED HELP!!! Setting up Mach3 with Gecko G320X and servos for a 3-axis router?

« on: September 18, 2020, 01:14:36 AM »

no i mean the wiring on the GEKO's

846

General Mach Discussion / Re: How to change feedrate on Mach turn

« on: September 17, 2020, 03:00:06 PM »

G95 is your friend.

847

General Mach Discussion / Re: NEED HELP!!! Setting up Mach3 with Gecko G320X and servos for a 3-axis router?

« on: September 17, 2020, 04:03:30 AM »

thank you for the photos.

there is not much to find about this BOB/Controller on the Internet.

so one Chance is follow up the wiring.

Looks like that one of this terminal blocks is for each axis.
would be interesting where the  blue orange red green White wires are connected to the servo Controller.

848

CS-Lab / Re: G31 Probe

« on: September 16, 2020, 03:56:04 PM »

It worked perfectly. My only complaint would be Single block doesn’t work in an M Code so it executed the whole script without stopping.

Single block in macros is not working!
BTW: the code is redicoulous anyway.

849

German / Re: Mach3 mit USB-Steuerungplatine Probleme

« on: September 16, 2020, 03:49:41 PM »

irgendwelche Neuigkeiten?
some new informations?

850

General Mach Discussion / Re: Pins and Ports for Fireball V90

« on: September 16, 2020, 03:30:46 PM »

Mach3 is not type of controller it is the software I paid $175 for to run my plasma cutter and anything else

WE KNOW THAT AND, WE ARE TRYING TO MAKE YOU THIS TO UNDRSTAND

Is the box messed up or why can’t Mach3 talk to it???

BECAUSE IT WAS NEVER DESIGNED TO TALK TO IT.

see my reply#18
LOOKS LIKE YOU DO NOT EVEN READ THE ANSWERES, MAY ALSO DEPEND ON MY BAD BAVARIAN ENGLISH.