11331
General Mach Discussion / Re: OD Taper Wizard Help Needed
« on: June 29, 2011, 06:06:55 PM »
That code seems to look fine for me with your xml, have you run it to see?
Hood
Hood
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
I am considering getting a Gecko G540 4 axis drive which is all encompassing, that's my only concern everything is in one unit so any problem the whole thing will need replacing.The G540 is actually made up of 4 drives and a motherboard, so any damage to one drive and that is all you will need to replace.