15221
General Mach Discussion / Re: Newbie Needs HELP!!!
« on: July 26, 2010, 07:47:55 PM »
Go into Ports and Pins then Outputs and disable Output 1 and 2 and see if that helps.
Hood
Hood
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
How do I MDI a G90?
Thanks Hood that worked!sounds like you are in Incremental mode (G91) so you are commanding a move of zero.
The only thing not functioning now is when I am in the midi screen, if I type G0, y0,x0 to return to home it there is no response.
The jog switch is activated. What can I do?
Thanks, PCH
Hood,
It is perhaps not a good idea to cut the air before the drill is fully retracted, what do you think ?
Tweakie.
QuoteTo me it looks like its just a physical switch that is operated as the Z goes below a certain height and that switch operates a solenoid for the air.
(I think the video shows that the air is cut at the start of the drill retract operation though).
Tweakie.