24161
General Mach Discussion / Re: All screwed up?
« on: December 02, 2007, 06:40:16 PM »
I dont know
It is dependant on your machines ballscrew pitch, motor type, drive type etc etc. Ther is however an easy way to do it, go to the settings page and click on the "set step per unit" button then follow the instructions for each axis. You will need some means of measuring the distance accurately, a dial gauge or vernier or similar should suffice.
Hood
It is dependant on your machines ballscrew pitch, motor type, drive type etc etc. Ther is however an easy way to do it, go to the settings page and click on the "set step per unit" button then follow the instructions for each axis. You will need some means of measuring the distance accurately, a dial gauge or vernier or similar should suffice.
Hood