1341
General Mach Discussion / Re: Help in diagnosing tool path problems created in LazyCAM
« on: September 01, 2019, 01:59:49 AM »
Your Gcode runs just fine here - there is no misalignment of the T & E characters.
(You may like to take a look at the free software 'F-Engrave' it will certainly create a better toolpath than the HPGL you are currently using).
Tweakie.
(You may like to take a look at the free software 'F-Engrave' it will certainly create a better toolpath than the HPGL you are currently using).
Tweakie.