3871
Mach Screens / Re: My screen
« on: January 27, 2016, 12:17:19 PM »
Nice work, a screen to be proud of.
Tweakie.
Tweakie.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
I have a problem where over 16 inches the actual span of a plasma cut part turns out to be about 15.96875. so I am losing about 1/32 over 16" This same error is also reflected in spacing between holes, so it is not a function of kerf width. Should this be adjusted in Scale DROs, or is there a better way to do this? I am concerned that if I make a correction here, running a code written by someone else will undo my correction and unnecessary scrap will be generated. Please advise.
Quotethats a sideways picture of the pulse output signal from breakout board on a scope.Really?
It looks like someone may have hacked the URL, because that 1st photo comes from anysex.com (it says so on the photo), and what the girl is doing to the man has nothing to do with CNC.
Perhaps a Mod needs to check?
Cheers