3231
General Mach Discussion / Re: Help: M6 macro acts weird
« on: January 14, 2013, 06:15:02 PM »
I can tell you form experience that it is NOT a good idea to use the M7/8/9 combo for anything other than than something like coollant or vac. They are tied into the matrix of the driver. Some in ways we have no idea that it is done that way.
I would suggest that you rethink your plans and use dedicated outputs mapped to dedicated pins and use seperate Mcodes to control them such as
M20 to close clamp
M21 to open clamp
M22 to activate air cylinder
M23 to deactivate Air cylinder
I think there are some industry standards for such I will look them up.
Just a thought,(;-)TP
I would suggest that you rethink your plans and use dedicated outputs mapped to dedicated pins and use seperate Mcodes to control them such as
M20 to close clamp
M21 to open clamp
M22 to activate air cylinder
M23 to deactivate Air cylinder
I think there are some industry standards for such I will look them up.
Just a thought,(;-)TP