Thanks
Now if Steve or Brian could map the Steps per, for each axis, We could set them up with something like X at .001 Y at .0001 and Z at .01
The way I have the buttons programmed now I can do it, as the data gets passed to the functions on selection of an axis. So by changing the steps per between axis selection the next axis is passed that new step value. Little convoluted but is possible.
Makes it nice in so many ways, but would put a lot more responsibility on the operator to Pay Attention. One of the most dangerous features of using hand dials is setting the steps per. Snap a cutter off mighty quick, as a step of 1" would surely make short use of small cutters or could ruin your workpiece.
Now to figure a way to get a remote LCD display. Would like Ethernet for control and display. Anyone have suggestions and/or examples
Maybe something like Peter Homann, ModIO only TSP Ethernet as opposed to serial.