9971
General Mach Discussion / Re: X axis is not working
« on: December 15, 2011, 09:22:52 AM »
The xml seems fine here and its jogging correctly.
Do you have the correct port address set? The one in your config is the normal one if using the onboard parallel port, if you have a PCI card it will be different so you will need to check in device manager if that is the case.
Hood
Do you have the correct port address set? The one in your config is the normal one if using the onboard parallel port, if you have a PCI card it will be different so you will need to check in device manager if that is the case.
Hood