5011
LazyCam (Beta) / Re: multiple passes
« on: February 06, 2010, 06:32:26 PM »
kasari,
All in the manual. You select a tool and send to all layers, then there is another one in the layers tab called Cut where you define how deep youwant each pass to be will go. The tool only defines the max depth of cut for that particular tool.
See section 8.3.2 & 8.3.4 in the manual.
Take a look through the manual and if you have any problem repost with you questions.
RICH
All in the manual. You select a tool and send to all layers, then there is another one in the layers tab called Cut where you define how deep you
See section 8.3.2 & 8.3.4 in the manual.
Take a look through the manual and if you have any problem repost with you questions.
RICH