3261
General Mach Discussion / Re: Building a new PC
« on: September 29, 2011, 05:28:51 PM »
The pc dosen't need to be the greatest , as compared to just a few years ago costs are low, and you can get a lot for your money these days. It's hard say that some pc will not be problematic. A few years ago i took a different approach and had one built ( cost about
$60 extra as compared if I had done it myself....but......the local company guarenteed it to work to my satisfaction for CNC work or they would replace or change out any component of it until it worked. If the component cost more then i would pay the difference in price. Can't beat that!
This is the basic components that mine has:
- Asus motherboard - M2N68-AM SE2
- 2 GIG Ram
- AMD 64X2 Dual Core Processor 5200+ 2.7 Ghz
- Asus graphics Card - EN9600GSO
- Rosewill PCI pp card - RC302
The PPS in the driver test will only change by 1 at 25khz. No changes were required and note that i didn't buy the best of components.
I am happy with it but really can't say you would be,
RICH
$60 extra as compared if I had done it myself....but......the local company guarenteed it to work to my satisfaction for CNC work or they would replace or change out any component of it until it worked. If the component cost more then i would pay the difference in price. Can't beat that!
This is the basic components that mine has:
- Asus motherboard - M2N68-AM SE2
- 2 GIG Ram
- AMD 64X2 Dual Core Processor 5200+ 2.7 Ghz
- Asus graphics Card - EN9600GSO
- Rosewill PCI pp card - RC302
The PPS in the driver test will only change by 1 at 25khz. No changes were required and note that i didn't buy the best of components.
I am happy with it but really can't say you would be,
RICH