Messages

1

Mach4 General Discussion / Compatible hardware

« on: December 02, 2023, 03:58:01 PM »

I have been trying to find the best Ethernet controller and break out board that works with Mach 4.

I have tried UC300Eth and ESS smooth stepper and have found they are very difficult to setup and keep running.  Any changes they crash.

I am running a simple 3 axis machine for wood routing.

2

General Mach Discussion / Re: "Probe Signal Inactive"

« on: December 02, 2023, 03:50:45 PM »

I have tested the probe circuit well it was running. There seems to be no voltage going through.
Tried moving to another input port and the same result. 
I have reinstalled Mach4 several times trying different builds.

3

General Mach Discussion / Re: "Probe Signal Inactive"

« on: December 01, 2023, 04:59:07 PM »

Hello
My probe just stopped working to my surprise and just kept moving into the spoil board.
I have a simple three axis wood router.
Using CNC4PC C94 breakout board, UC300ETH controller and Mach 4
I was installing a pendant MPG2, which never worked as well.  But when I started a new project the probe stopped working.
I have reinstalled all of my software several times using new and old builds and cannot get a touch signal out of the board.
I do have continuity in the probe circuit.