Just tried 2.2 plugin on the wee lathe and its fine. As said I use servos so probably not a perfect comparison.
Hood
I use servo's too and although you might not hear a difference it is obvious that the steps are "shorter". At certain revs of the hand wheel it causes a motion as if attached to a rubber band. Also on my Z axis the brake is making more noise compared to before.
I can assure you I do not suffer from this issue, I dont use the small lathe much but today I fired it up to check this again but this time more thoroughly and it does not display this problem. The Chiron I use daily and again does not display this issue.
Why some people have this issue and some not I am unsure, maybe acceleration differences?
I am sure CS-Lab will get it sorted soon, for the people that have the issue, in the mean time I think if I had the issue I would just revert to the previous version as that should clear up the issue.
I dont understand about your brake, how is that configured?
Hood