18791
General Mach Discussion / Re: Profile toolpath problem
« on: June 20, 2009, 02:56:21 PM »
Just looking at your xml at the moment, I have noticed that you have Input 1 set to Port 1 Pin 1, that is not correct as pin 1 is an OutPut. Its not likely your problem but that may depend on what you are using OutPut 1 as you have it set up to the same port and pin. I will continue looking at the xml and see if I can find the problem.
The corners however are likely to be backlash so check everything is tight such as pulleys on motors and screws etc.
Hood
The corners however are likely to be backlash so check everything is tight such as pulleys on motors and screws etc.
Hood