18181
General Mach Discussion / Re: Unable to connect to CNC
« on: August 25, 2009, 05:51:17 PM »
LOL, well if only I had been awake or TP had come in sooner then you could have had time to catch the trout by now.
Hood
Hood
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
OK YOU are giving data for a COM(serial ) port .You have to use the LPT(parrallel) port.
Set up mach for the LPTport that XP shows.
Hope that helps, (;-0 TP