1
Mach3 and G-Rex / [MACH3 with G100] ecode=777, ecode=790, ecode=813
« on: July 29, 2008, 03:19:28 PM »Dear all G100 user!
Hi! I'm Kris.
I'm using MACH3 with G100. And I have some problem.
First I can launch firmware load when Grex shows me red light.
And I can ping Grex always. 0% loss. So I'm sure I have static IP adress.
But after motor tuning in Mach3, I always see error message as attached file.
I did searched all topic about "ecode=777", "ecode=790" and "ecode=813".
And I tried all firmware and plugin I can get. (But I'm not sure I have right...)
Does anybody know about this problem?
Please help me~~~