11241
Works in progress / Re: THE LATHE PROJECT - 2011
« on: July 14, 2011, 04:57:34 PM »
So, if YOU, HOOD, Graham, (and other PRO level lathe users), would please chime in on exactly WHAT needs to be on each screen and how many screens are really needed......
Scott I think everyone is different as to what they use, I have 4 pages to my screens but very rarely use any other than the main page. I have all I use on that page day to day. The other pages I have are a half finished diagnostics page that I never look at so its unlikely to get finished. A tool setup page that I only obviously use if I set up a new tool and a tool table page which I look at when I am writing code and need to know which tools will be in which position on the turrets and which offsets they are using. Below are the screenshots of these pages but as said everyone will have different requirements and it wil be difficult to make a screen up that everyone likes, just ask Steve
Oh BTW I have the MDI on both the main and Tool Setup page.
Hood