7
« on: December 31, 2009, 09:48:10 AM »
No. I have a 4 axis mill and controller that has gecko 201 drives, charge pump, 3 home switches and a probe, nema23 250oz-in 0.9deg steppers, and a couple 110VAC relays and my computer is more than ample to run mach, using XP pro. I've been through many versions of mach over the past 4 years and all have worked fine for the most part.
I went back to ver 0.020 and velocity behavior goes back to normal. Tried version 0.033 again after that and overfeed happens so there is definitely a software issue. I do use my own screen set, I'm going to try to use the default install, screen, and xml to see if maybe something from my screen set iis causing this. I have 2 machines so I will also try this on my other machine.