781
General Mach Discussion / Re: finding x0 yo
« on: August 26, 2007, 09:05:03 AM »
You can set the rotation of the object wit a G68 and if you need to move the 0,0 position you can jog to that position and type in Zero into each DRO. after you ahve done that if you regen the toolpath you should see where on the part you are. I think you are asking to see a small dot on the screen to show where the zero zero of the file is and as that is a good idea you will not see it in Mach3 but you may see that in Quantum