4231
General Mach Discussion / Re: Problem with z axis cut
« on: September 08, 2015, 11:53:32 AM »
We all seem to have our own personal choice but I use R3.043.056 if that's any help.
Tweakie.
Tweakie.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Hi,
When I make a 3D text with Aspire 4.0 to Mach3, it looks okay on Aspire but when i start it on Mach3 and it should start at the top off the wood (cutting at 1mm) but it cuts straith in to the wood about 10 - 20mm Why??
Thanks!!
Thomas
OK,thanks again this is a USB connected card not parallel does that make a difference?