781
G-Code, CAD, and CAM discussions / Re: Chinese breakout board BSMCEO4U-PP
« on: September 10, 2020, 01:20:26 AM »
A couple of things come to mind...
Use the Vectric PP Mach2/3 Arcs Inch.
Check that you have Vectric set-up in Inches (not mm) when you create the image.
Check that you have set-up Mach3 in Inches.
Use the Steps per Unit calculator (Diagnostics page) to check that you have each of your axis steps set correctly.
Check that you do not have G21 in your Initialization String (Config / General Config.).
Tweakie.
Use the Vectric PP Mach2/3 Arcs Inch.
Check that you have Vectric set-up in Inches (not mm) when you create the image.
Check that you have set-up Mach3 in Inches.
Use the Steps per Unit calculator (Diagnostics page) to check that you have each of your axis steps set correctly.
Check that you do not have G21 in your Initialization String (Config / General Config.).
Tweakie.