20261
General Mach Discussion / Re: external estop problem
« on: February 02, 2009, 08:46:43 AM »
Ok to confirm what is happening, you can reset and all is well until you jog the Z axis and when you do that the Reset flashes?
Is that correct?
Try setting the debounce Interval to 2000 and see if that helps.
Also I have noticed that you have Enhanced pulseing disabled, best with that enabled on 99.9% of systems.
Both of these can be found from Config menu then General Config.
Hood
Is that correct?
Try setting the debounce Interval to 2000 and see if that helps.
Also I have noticed that you have Enhanced pulseing disabled, best with that enabled on 99.9% of systems.
Both of these can be found from Config menu then General Config.
Hood