Greetings everyone. I am stuck and need help.
I have a WorkBee CNC. It came with Novusun controllers, and based on the advice on this board I swapped it out for Warp 9 ESS control system with a G540 to drive the motors.
I am operating the spindle manually for now and will worry about that later. The ESS is installed in Mach 4 and it does see it. The ESS and the G540 are connected with the 25 pin ribbon cable I ordered with it. I have the G540 installed with the light green and power goes to all the motors holding them in place. I also used the G540 to connect to the limit switches and E-stop. The E-stop does work and turns the G540 light red, but it's not seen by Mach 4. The limit switches are not seen by Mach 4 either.
I have read all 41 pages of the ESS manual and the G540 manual. My problem is assigning ports/pins, therefore I am stuck. I can see the pin number assignments in the G540 manual, but don't know how to assign them in Mach 4.
I would greatly appreciate any help. This has been a long process with me assembling this CNC back in May.