3361
General Mach Discussion / Re: GCode problem
« on: January 15, 2014, 04:06:12 PM »
Have a look at your machine coords and see where your Z0 is.
Are you homing the mill?
The code is not defined as far as metric or imperial, ie no G21 or G20 in it so it will run in whatever Mach is currently set to, you will see that at the top of the main screen, either G20 (Imperial) or G21(Metric)
Hood
Are you homing the mill?
The code is not defined as far as metric or imperial, ie no G21 or G20 in it so it will run in whatever Mach is currently set to, you will see that at the top of the main screen, either G20 (Imperial) or G21(Metric)
Hood