2111
General Mach Discussion / Re: Just joined....so hi all!!
« on: November 20, 2014, 01:42:58 PM »Quote
How do I cut multiples of the same thing and allow the machine to run continuously?
You can do this a few ways but ave a look at the nesting wizard, it may be your best bet. What you do is load your code then press Edit, replace the M30 at the end with M99, you then go to wizards and choose the nesting wizard. Once open choose the amount of repeats in X in Y that you want and the distance between then press create file.
Quote
Can I import G-code and place it where I need it? (this would solve everything I believe)
Yes just jog to where you want the X Y Z zero to be and press the Zero buttons at the side of the axes DROs.
Hood