1
Mach3 and G-Rex / Mach 4, G-Rex and linear encoders...
« on: May 02, 2006, 04:36:32 PM »
Hi, i have a question.....
I have a g100, 3 servo, and 3 linear encoders, i use mach 4 in metric units, but what is the optimal motor tuning config for my system?
I have set same of the tutorial, but the value of encoders it does not come considered in the movements of the system..... Why? is it correct ?
Thanks and hello to all!
p.s. sorry for my bad english...
I have a g100, 3 servo, and 3 linear encoders, i use mach 4 in metric units, but what is the optimal motor tuning config for my system?
I have set same of the tutorial, but the value of encoders it does not come considered in the movements of the system..... Why? is it correct ?
Thanks and hello to all!
p.s. sorry for my bad english...