1791
General Mach Discussion / Re: Is this drawing too much for LazyCam?
« on: January 02, 2007, 02:18:50 PM »
Hi, Mills
Try this one, loaded it into my Turbocad 8 and saved it loads fine now.
When you save your DXF save it in oldest Acad DXF format you have, ver 12 or 14,r
LazyCam is-sent compatible with all DXF formats.
Hope this Helps, Chip
Try this one, loaded it into my Turbocad 8 and saved it loads fine now.
When you save your DXF save it in oldest Acad DXF format you have, ver 12 or 14,r
LazyCam is-sent compatible with all DXF formats.
Hope this Helps, Chip