851
General Mach Discussion / Re: Unable to limit feed rate on Z axis..What am i doing wrong?
« on: July 31, 2020, 03:04:55 AM »Alright the issue is back. Sometimes it will work on one line of code and not work on another line in the same program.
Mach3 is sometimes limiting the Z axis motor to the speed in motor tuning and sometimes not.
I sure am glad i paid for this buggy pile of ********* with no support.
It's understandable and I suppose you have to blame somebody but in your case Mach3 is just acting as the Motion Planner the actual and true control of your machine is all handled by your Langmuir Motion Controller.
Tweakie.
EDIT; Additional information.
Quote
I have the Z axis set to 50ipm.
Reduce your Z axis Velocity in Motor Tuning to 39 and save the change.