This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Filename | Downloads | Message | Posted |
---|---|---|---|
LOOP TEST CODE_HCIR.jpg | 416 | MISSING STEPS HCIR | February 27, 2011, 04:57:48 PM |
cncameteur_hcir.dxf | 322 | Re: Cutter compensation issues... | March 07, 2011, 06:12:22 PM |
cncametuer_hcir.jpg | 600 | Re: Cutter compensation issues... | March 07, 2011, 06:12:22 PM |
NLS_HCIR 1.jpg | 743 | Re: THE LATHE PROJECT - 2011 | March 20, 2011, 08:48:32 PM |
MACH & FEED RATES.pdf | 629 | Re: 4th axis setup | March 29, 2011, 04:57:17 PM |
RADI COMMENT_HCIR.jpg | 446 | Re: Issue with offset | March 30, 2011, 07:20:19 PM |
CB_CONE ON STOCK_HCIR 1.jpg | 340 | Re: I Wish There Was A Wizard For This! | April 17, 2011, 07:29:58 AM |
CB_CONE ON STOCK_HCIR 2.jpg | 436 | Re: I Wish There Was A Wizard For This! | April 17, 2011, 07:29:58 AM |
tailstock_HCIR.jpg | 502 | Re: Restore Lathe Tailstock | April 19, 2011, 05:22:00 PM |
CIRCLES_VMR.jpg | 400 | Re: Problems with circles and plines | April 21, 2011, 06:03:36 PM |