3041
General Mach Discussion / Re: Help Setting Up a Laser Cross-hair in Mach3 Using 2010 Screenset
« on: October 14, 2013, 06:47:08 PM »
Use a screen designer to add a VB script button to the screen, and assign the Hotkey to the button.
Then write a script to toggle the output on and off.
The script would be something like this:
If not IsActive(OUTPUT5) then
ActivateSignal(OUTPUT5)
Else
DeActivateSignal(OUTPUT5)
End If
I'm not sure if this is 100% correct. You'll need to do some research.
Then write a script to toggle the output on and off.
The script would be something like this:
If not IsActive(OUTPUT5) then
ActivateSignal(OUTPUT5)
Else
DeActivateSignal(OUTPUT5)
End If
I'm not sure if this is 100% correct. You'll need to do some research.