Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Filename	Downloads	Message	Posted
alc.jpg	2779	Re: Mach 3 moving the ZERO start point	April 02, 2010, 12:06:30 PM
alc1.jpg	1979	Re: Mach 3 moving the ZERO start point	April 02, 2010, 12:06:30 PM
slight_hcir.jpg	616	Re: Why no tool path?	April 02, 2010, 06:13:53 PM
SENSOR SCH_HCIR.JPG	446	Re: RPM and counting ?	April 03, 2010, 08:05:30 AM
APPENDIX_F_updateHCIR.pdf	3191	Re: How do you set the home position and do a simple 2d profile	April 03, 2010, 08:21:46 AM
2002 save as.jpg	607	Re: fine cutpath issue?	April 03, 2010, 08:59:41 PM
open gl error HCIR.jpg	604	Re: open gl error?	April 10, 2010, 07:50:20 AM
48 hcir reply.pdf	390	Re: LazyTurn	April 19, 2010, 09:38:02 AM
negative value_hcir.jpg	715	Re: LazyTurn	April 19, 2010, 11:58:39 PM
48_2convert2d.dxf	329	Re: LazyTurn	April 21, 2010, 10:06:28 AM