0 Members and 1 Guest are viewing this topic.
Hi Allan,Do not wire two steppers to the same axis.As you are using the UC400ETH controller you could set an Output Pin from Port#2 for your spindle. I am assuming that you will be using a different profile for your spindle working to your laser working.At the moment the conflict that I mentioned earlier is switching your laser (Port#1 Pin 17) from the M3/M5 commands and not the M11/M10 commands.Tweakie.
Hi TweakieJust so you know what I've done,I have wired the both my Y axis motors to the Y axis outputs on the CP0-10V, Swapped the A+ & A- on the slave stepper motor, this has given me pin 8 & 9 free. Is that wrong?Allan
So would I now set in output signals Output#2 - Port#2 & Pin#8What do I set Output#1 to?