2281
General Mach Discussion / Re: 1 drive 3 axes and mach 3
« on: October 10, 2014, 03:30:41 AM »
Mach itself could not send the signal to one drive when commanding different axes but it is likely you could trick it into doing so. It would not be straight forward as you would need to have a Mcode before each move of a different axis. That MCode would operate relays that would swap the outputs from your controller so that tey feed the axis drive, it would also be used to energise the magnetic clutch.
It is not an elegant solution but it should work.
Hood
It is not an elegant solution but it should work.
Hood