1311
Newfangled Solutions Mach3 Wizards / Re: Y axis moving in the wrong direction
« on: October 02, 2019, 01:18:40 AM »
As mentioned in your attached .pdf file - changing the Direction Low Active state of an axis (and saving the changes) will cause that axis to move in the opposite direction.
It is a bit confusing because the correct direction is really the direction the TOOL moves in relation to the work and if you have a moving table then the table has to move in the opposite direction to achieve this.
Hope this helps.
It is a bit confusing because the correct direction is really the direction the TOOL moves in relation to the work and if you have a moving table then the table has to move in the opposite direction to achieve this.
Hope this helps.