The currently locked version of Mach3 is crashing my laptop. (Mach3 2.0.065)
It runs, I also found the right steps for the A-Axis sherline table and I can jog and enter G-Code all day long.
The moment I load a generated file for example from DeskProto) Mach3 starts working on it and randomly between line 10 and 100 it crashes my laptop so bad the the mouse cursor stops moving and I have to actually take the battery out to kill it.
The G-Code is about 2MB and is displayed alright in the little window (can I make that LARGERRRR
).
Software installed is deskproto rhino4 and mach3.
I also went through the optimization and deleted or switched off anything recommended there.
I have 1GB Ram and a P4 with 2.4GHz speed.
Any Ideas where I can look for problems?
Stuck Lemo