6931
General Mach Discussion / Re: Probe wiring
« on: June 01, 2011, 01:53:28 AM »
I think you need to return to what Terry said earlier;
"From the MDI screen type G31 X-2 F10 (followed by return) . The machine should start moving in the X- direction then trip the probe with your finger to see if it stops".
If the machine does not move, then we need to establish why.
Does the X Axis DRO indicate the move ?
Tweakie.
"From the MDI screen type G31 X-2 F10 (followed by return) . The machine should start moving in the X- direction then trip the probe with your finger to see if it stops".
If the machine does not move, then we need to establish why.
Does the X Axis DRO indicate the move ?
Tweakie.