5611
Show"N"Tell ( What you have made with your CNC machine.) / Re: Isolation Routing PCB's and Local System Rotate.
« on: December 01, 2012, 04:24:59 AM »
I have just discovered a problem with my particular little webcam – it appears that the guts are assembled to the cable then drawn into the housing and only secured at the cable exit end. When fitted to the machine, if the cable is moved (twisted) the internal image sensor can rotate slightly thus spoiling the accuracy of the positioning / setup.
My solution was to remove (destroy) the front window, apply a couple of spots of adhesive to secure the image sensor PCB to the housing then fit a new window (it was doubtful if the existing window could be removed without damaging it). There is probably a better (easier) way to solve this problem but the image sensor PCB is now secure and all is well again.
Tweakie.
My solution was to remove (destroy) the front window, apply a couple of spots of adhesive to secure the image sensor PCB to the housing then fit a new window (it was doubtful if the existing window could be removed without damaging it). There is probably a better (easier) way to solve this problem but the image sensor PCB is now secure and all is well again.
Tweakie.