3371
General Mach Discussion / Re: Moving to lower Z point directly after start
« on: January 15, 2014, 10:35:44 AM »
This line is telling Mach to set the height offset and go to Z10
G43 H1 D31 G0 X24.984 Y9.94 Z10. S1000 M3
Then Mach is told to rapid to Z2 and then this line tells Mach to go to Z-1 with a feed of 33 units per min.
G1 Z-1. F33
So looks to me like Mach is doing as it is told. Maybe you are used to having Z0 as fully down, seems some router guys work that way instead of Z0 being the top of the work as is the way with most people with mills.
Hood
G43 H1 D31 G0 X24.984 Y9.94 Z10. S1000 M3
Then Mach is told to rapid to Z2 and then this line tells Mach to go to Z-1 with a feed of 33 units per min.
G1 Z-1. F33
So looks to me like Mach is doing as it is told. Maybe you are used to having Z0 as fully down, seems some router guys work that way instead of Z0 being the top of the work as is the way with most people with mills.
Hood