701
General Mach Discussion / Re: Mach-3 and L-cam for the lathe
« on: September 20, 2007, 10:44:49 PM »
Lcam is what will be used to make a DXF into a lathe program...
I hope the work slows down and I can get back at Lcam hard! I would like to have it doen for the most part... I have about 2 weeks work to finishe what I need to work on in Lcam.
I hope the work slows down and I can get back at Lcam hard! I would like to have it doen for the most part... I have about 2 weeks work to finishe what I need to work on in Lcam.