2791
General Mach Discussion / Re: Mach/Gecko3x0/ speed limits ?
« on: June 12, 2006, 07:46:42 PM »
You are limited to a 45Khz Step rate and that works out to about 1300RPM of the servo motor. You say there is a 2" Dia pulley driving so that works out to about 408IPM if you have a 20 to one reduction and the resolution is about .000157 per step... I would think about getting 250 count encoders and you will not have to stress the software and computer as much That will give you more IPM and the resolution will be about .000314 ish...
That was a nice break form the code Hope it is a help!
Brian
That was a nice break form the code Hope it is a help!
Brian