1791
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Hi Friends,
Totally new to DIY-CNC and need your help and support to run my single motor in X axis (Pul/Dir).
I bought Rhino 10kgcm Nema 23 motor with DM542 stepper driver and trying to drive with 24VDC 14.5Amps power supply and 5 axis optical isolated board from Rrmin (Chinese make).
I did the connections as per general guidelines provided on internet, Everything seems fine but motor is not running.
Please support to figure out what is wrong and how to correct it
Maverick