2001
General Mach Discussion / Re: Mach 3 & Denford Orac spindle speed headache!!
« on: January 01, 2015, 08:38:42 AM »
One point to remember is that the speed set in spindle pulleys can affect the displayed value.
Or at least that is the case when using an external controller, cant remember if its the same with the parallel port as it has been a long time since I used one.
So anyway if you have a max rpm of 2000 you should set that in Spindle Pulleys so that the correct RPM will be displayed.
Hood
Or at least that is the case when using an external controller, cant remember if its the same with the parallel port as it has been a long time since I used one.
So anyway if you have a max rpm of 2000 you should set that in Spindle Pulleys so that the correct RPM will be displayed.
Hood