7021
General Mach Discussion / Re: Mach3 loses Y axis location during code
« on: May 04, 2011, 02:23:25 AM »
Chad,
I am using version R3.043.022 and I just had a problem with X position when running your code.
May be me or it may be the code or it may just be the length / size of the code, in any event it deserves further investigation. I will try it again later and see just what is going on.
Tweakie.
I am using version R3.043.022 and I just had a problem with X position when running your code.
May be me or it may be the code or it may just be the length / size of the code, in any event it deserves further investigation. I will try it again later and see just what is going on.
Tweakie.