14911
General Mach Discussion / Re: F for feedrate
« on: September 04, 2010, 04:05:07 PM »
Ok maybe this will explain things better.
If you are at X0Y0 and you command a move of G1 X10 Y1 F10 the two axis will move at a feedrate of 10 on a diagonal line, obviously tye Y axis does not have so far to travel as the X so the speed of that axis will be a lot slower than the X but the actual tool will move at a feedrate of 10.
Hood
If you are at X0Y0 and you command a move of G1 X10 Y1 F10 the two axis will move at a feedrate of 10 on a diagonal line, obviously tye Y axis does not have so far to travel as the X so the speed of that axis will be a lot slower than the X but the actual tool will move at a feedrate of 10.
Hood