11771
General Mach Discussion / Re: Random Loss X-Y axis
« on: May 04, 2011, 05:17:01 PM »
Ok so sounds like as far as Mach is concerned all is on track.
What kernel do you have Mach set to? (Config menu then Ports and Pins)
What does the driver test look like when running it at the kernel you are running?
Sounds like the On Position is what most call Following Eroor. Is it a fixed value? ie less than 127 counts? Or can you adjust and if so what have you set?
Hood
What kernel do you have Mach set to? (Config menu then Ports and Pins)
What does the driver test look like when running it at the kernel you are running?
Sounds like the On Position is what most call Following Eroor. Is it a fixed value? ie less than 127 counts? Or can you adjust and if so what have you set?
Hood