Be careful to NOT mix units.
If drawing units are metric, tool needs to be dimensioned accordingly. .040" =1.0mm tool dia.
Works fine here with a 1, 2, 3, or 4 unit diameter tool. .030" = .762mm
Russ
« Last Edit: February 17, 2010, 12:17:44 AM by Overloaded »
This might be my problem, but I thought LC looked at drawings as units of measurement, metric or imperial didn't matter? If you import a drawing that was done in metric do you use a tool from the menu in metric as well? eg If drawing was done in metric and you use a cutter with a dia. of 1mm you need to have tool dia. set at 1 and not .039"? If this is indeed true then this would explain why I don't see the offset line. It would be applying an offset of .039mm. Hope I conveyed that in a way you can understand it.