22141
General Mach Discussion / Re: dual x axis direct drive jumpy
« on: August 15, 2008, 05:29:49 PM »
you got a link to your drives?
Hood
Hood
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Hello,
First of all,thanks for the smooth stepper.
There are some points i would like to clear before going to buy smooth stepper.
1.the current smooth stepper is a beta version.so later by updating
the only firmware make it stable?imean what if some hardware changes
comes in to the picture.as iam planning to sell the machines made by
smooth stepper,i can't run around changing the hardware settings.i
want the system completely fool proof.
2.i red in the manual,that the smooth stepper shld be placed in an
static free environment.that means does it uses some micro controller
to run the inside logic.why iam curious abt this is,even a small
amount of static energy will wipe out the micro controller.so how can
i handle such situations.
3.there are 2 ports in the smooth stepper.can you tell me which one of
these are inputs and outputs and which one is pwm for spindle control?
and your manual said its upto the user to choose either way.imean
24outsputs and 16 inputs vice-versa.upon configuration.how to do this.
4.i'll be using AC servo system(along with noise filter)to run my
axes.which takes step and direction as inputs.it worked on normal
parallel port.can i expect same from smooth stepper.
can you send the shipment cost and details,so
that i can place my order as soon as possible.and is it possible to
manually pick the SS(i need to know where your located).i have some
friends in US and UK
i'll be waiting for your reply
thanks and regards