You were correct. I had the power supply on the wrong side. I feel so dumb.
Hooked it up correctly and the weird thing is nothing changed.
X still works. The other three axis do not work.
So, did I burn out two boards with them being hooked up backwards? And why would this stupid thing work with the X-axis no matter how it's hooked up? I know this is stepping outside of the Mach3 software questions at this point and do appreciate the help I've received.
so have you tried to swap X an Y Step/Dir Connection on your breakout board ?
have you configured enable pin14 now ?
can you please post your XML ?
your axis dro's are changing on Screen if you move the other axis ?